Harken 447 Dinghy Vang System Manuale Utente Scaricare il pdf

407

405

Lower line

(5 mm)

Upper line

(3 mm)

Lower assembly

(455 if purchased separately)

Max working load = 450 lb (204 kg)

Breaking load = 1200 lb (544 kg)

Max sail area = 125 ft

(11.6 m)

Parts included (447 only)

Lower assembly

16mm AirBlock

405

Upper block 16 mm AirBlock

w/becket #407

Upper Line: 10' of 3mm polyester line

Lower Line: 10' of 5mm polyester line

Tools you must supply

Drill motor

5/32" (4 mm) drill bit (for screws)

10-32 (5 x .80 mm) tap (for screws)

Screw driver (for screws)

3/16" (5mm) drill bit (if pop rivets are used)

Pop rivet gun (optional)

Centerpunch

Pencil or fine-point marker

Parts you must supply

10-32 (5x .80 mm) stainless steel screws

(optional)

– or –

3/16" (5 mm) stainless steel pop rivets

Use shackle (246) if there is a bail or strap

to attach upper block to boom.

Use eyestrap (073) if there is no bail on

boom.

The enclosed vang is not for use on the

Laser. The Laser vang is a different part

and is only available through Laser

builders or their dealers. Please contact

your Laser dealer regarding availability.

INSTALLATION SHEET

15:1 Power Dinghy Vang

447 (System) or 455 (Lower Assembly)

N15W24983 Bluemound Road • Pewaukee, WI 53072 U.S.A.

Telephone: (262) 691-3320 • Fax: (262) 701-5780

Web: www.harken.com • Email: [email protected]

1 2 3 4

Sommario

Pagina 1 - 15:1 Power Dinghy Vang

407405Lower line(5 mm)Upper line(3 mm)Lower assembly(455 if purchased separately)Max working load = 450 lb (204 kg)Breaking load = 1200 lb (544 kg)Max

Pagina 2 - Part 1 – Reeving Line

Part 1 – Reeving LineNote: The following section is for replacing line on the 447 system, or assembling if you purchased the 455 separately. If you pu

Pagina 3

Note: If bracket does not fit mast, put it in a vice and squeeze slightly to fit.too much gapPart 2 – Mounting InstructionsMounting optionsMount the D

Pagina 4 - Warranty

Mount the bracket to the mast using: #10 Screws: Stainless Recommended 10-32 (5 x .80 mm) screws Drill 5/32(4 mm) for tapping Tap with a 10-3