Harken 60.3ST Winche Manuale Utente

Radial Winch 60.3 STInstallation and Maintenance ManualMRW-01

10Radial Winch 60.3 STInstallation and Maintenance Manual15. Remove gear n°10 16. Remove the gear n°217. Remove the roller bearing n°1213. Remove the

11Radial Winch 60.3 STInstallation and Maintenance ManualInspect balls inside the drum and carefully check the correct position; if it is necessary to

12Radial Winch 60.3 STInstallation and Maintenance ManualExplodedviewwithmaintenanceproducts1.ApplyHarken®greaseonassysocketscrew-2.Appl

13Radial Winch 60.3 STInstallation and Maintenance ManualAssemblyMake sure that the holes and drainage channels in the base of the winch are not obstr

14Radial Winch 60.3 STInstallation and Maintenance ManualHarken®limitedworldwidewarrantyRefer to the Harken® Limited Worldwide Warranty in the Hark

15Radial Winch 60.3 STInstallation and Maintenance ManualExploded view23263721282729301716182524192036353433543132764532122149131211155410838...Explo

16Radial Winch 60.3 STInstallation and Maintenance Manual23263721282729301716182524192036353433543132764532122149131211155410838...

17Radial Winch 60.3 STInstallation and Maintenance Manual*Servicekitavailable;seewinchkitsectiononthewebsitewww.harken.com**Winchproductst

18Radial Winch 60.3 STInstallation and Maintenance Manual*Servicekitavailable;seewinchkitsectiononthewebsitewww.harken.com**Winchproductst

19Radial Winch 60.3 STInstallation and Maintenance Manual*Servicekitavailable;seewinchkitsectiononthewebsitewww.harken.com**Winchproductst

2Radial Winch 60.3 STInstallation and Maintenance ManualIndexIntroduction 3Technicalcharacteristics 3Weights 3Maximumworkingload 3Outline 3Ins

3Radial Winch 60.3 STInstallation and Maintenance ManualIntroductionThis manual gives technical information on winch installation and maintenance, inc

4Radial Winch 60.3 STInstallation and Maintenance ManualInstallationThe winch must be installed on a at area of the deck, reinforced if necessary to

5Radial Winch 60.3 STInstallation and Maintenance Manual Torque to apply when assembling 1. Unscrew the central screw ( 2Nm/18 in-lb)2. Slide off

6Radial Winch 60.3 STInstallation and Maintenance Manual10. Remove the drum support n°166. Remove the stripper arm housing n°21Install the winch on th

7Radial Winch 60.3 STInstallation and Maintenance ManualB. Remove the winch and drill the six 8.5 mm diameter holes.C. Bolt the base of the winch to t

8Radial Winch 60.3 STInstallation and Maintenance ManualMaintenanceWashingWinches must be washed frequently with fresh water, and in any case after ea

9Radial Winch 60.3 STInstallation and Maintenance Manual9. Unscrew the 6 hex screws n°17 (20Nm/177 in-lb)10. Slide out the drum support n°1611. Remov