Harken 1093 Carbon Jib Reefing & Furling Manuale Utente

Carbon Jib Reefing & Furling Installation ManualUnit 2/2.5

10 2/2.5 Carbon Furler December 2001 ASSEMBLY Lay plastic against foil and place splint against foil. Tightly wrap clear packaging tape around spli

ASSEMBLY December 2001 2/2.5 Carbon Furler 11Slide lower unit onto bottom foil. Assemble turnbuckle. Attach turnbuckle eye to toggle using cross p

12 2/2.5 Carbon Furler December 2001 COMMISSIONING Tying Soft Attachment LinesYou must lace line around the furler/halyard swivel three times when

COMMISSIONING Tying Soft Attachment Lines December 2001 2/2.5 Carbon Furler 134 Pass other end up and over crossing lines and then down into loo

COMMISSIONING Tying Soft Attachment Lines 14 2/2.5 Carbon Furler December 20017 Finished bend drawn up and set. If your bend does not look like

COMMISSIONING Halyard Wraps • Prevent Halyard Wraps December 2001 2/2.5 Carbon Furler 15 HALYARD WRAPSThe most serious problem with furling sy

COMMISSIONING Pendants • Halyard Restrainer 16 2/2.5 Carbon Furler December 2001 PENDANTSIf your sail is not long enough to position halyard swi

COMMISSIONING Halyard Tension December 2001 2/2.5 Carbon Furler 17 HALYARD TENSIONThe jib halyard should be firm, but not too tight.TIP: The luf

Corporate Headquarters1251 East Wisconsin Avenue, Pewaukee, Wisconsin 53072 USA Telephone: (262) 691-3320 • Fax: (262) 691-3008 • Cable: Harken Pewauk

2 2/2.5 Carbon Furler December 2001 TABLE OF CONTENTS Parts 3Pictures and list of all partsSpecifications 4Rod sizesClevis pin sizesLuff tape s

May 2002 2/2.5 Carbon Furler 3 PARTS Cross pin*Cotter pinToggleClevis pinSmalley RingPrefeeder*Cross pin includes (2) H2912A bushings.(36) Connecto

4 2/2.5 Carbon Furler May 2002 SPECIFICATIONS ROD SIZES-12, -17, -22 (7.14mm, 8.38mm, 9.53mm) CLEVIS PIN SIZES5/8", 3/4" (15.9 mm, 19.

June 2002 2/2.5 Carbon Furler 5 PREPARATION FOR ASSEMBLY Foil Cut Length • Top Foil Cut Length • Short Top Foil? • Cutting Top Foil Dimensions

6 2/2.5 Carbon Furler December 2001 PREPARATION FOR ASSEMBLY Tape outside ends of all foils using blue masking tape. To make sure tape edge lines

June 2002 2/2.5 Carbon Furler 7 ASSEMBLY Assuming that installation is done from the top, slide bottom foil onto rod so end with holes is at botto

ASSEMBLY Remove plastic clip from Hysol® adhesive pack.1) Mix for five minutes in bag. 2) Pour entire contents into cup.3) Squeegee remaining epoxy

May 2002 2/2.5 Carbon Furler 9 ASSEMBLY Lightly coat feeder area of connector and slip feeder into place. Use glue brush to coat inside of foil for