Harken 20.2PT Winche Manuale Utente

Radial Winch 20.2 PTInstallation and Maintenance ManualMRW-01

10Radial Winch 20.2 PTInstallation and Maintenance Manual7. Slide off gear n°39. Unscrew the screw n°10 and remove the washer n°9 (4Nm/35 in-lb)8. Sli

11Radial Winch 20.2 PTInstallation and Maintenance ManualExploded view with maintenance products1Apply Harken® grease on assy socket screw 2Apply Hark

12Radial Winch 20.2 PTInstallation and Maintenance ManualAssemblyMake sure that the holes and drainage channels in the base of the winch are not obstr

13Radial Winch 20.2 PTInstallation and Maintenance ManualHeadquartersHarken®, Inc.1251 East Wisconsin AvenuePewaukee, Wisconsin 53072-3755 USATel: (26

14Radial Winch 20.2 PTInstallation and Maintenance ManualExploded view 1/221451145736109845

15Radial Winch 20.2 PTInstallation and Maintenance ManualExploded view 2/21413151217181920541621

16Radial Winch 20.2 PTInstallation and Maintenance Manual*Service kit available; see winch kit section on the website www.harken.com**Winch product st

2Radial Winch 20.2 PTInstallation and Maintenance ManualIntroductionTechnical characteristicsWeightMaximum working loadOutlineInstallationProcedure 1P

3Radial Winch 20.2 PTInstallation and Maintenance ManualIntroduction - Technical characteristics - OutlineIntroductionThis manual gives technical info

4Radial Winch 20.2 PTInstallation and Maintenance ManualInstallationThe winch must be installed on a at area of the deck, reinforced if necessary to

5Radial Winch 20.2 PTInstallation and Maintenance ManualThe winch can be installed following one of the two procedures below (Procedure1 or Procedure

6Radial Winch 20.2 PTInstallation and Maintenance ManualProcedure 2To install, you must remove the winch skirt and use hexagonal headed bolts.Tools ne

7Radial Winch 20.2 PTInstallation and Maintenance ManualNOTICEMake sure the skirt is correctly clipped on to the base of the winch. Install the winch

8Radial Winch 20.2 PTInstallation and Maintenance Manual B. Remove the winch and drill the ve 6.2 mm diameter holes.C. Bolt the base of the winch to

9Radial Winch 20.2 PTInstallation and Maintenance ManualWARNING!Periodic maintenance must be carried out regularly. Lack of adequate maintenance short